AeroGain Custom Mono Arm Rest

Single piece armrest with high supporting sides. The high edges give you something to brace against, which enables you to maintain your optimal aerodynamic position and keep your shoulders narrow. They are customised to the desired width of each buyer (up to 24 cm), and customised to fit the bolt pattern of each riders bike. Production time is 2-3 workdays.
The seamless mono arm rest design keeps the front end cleaner that a dual arm rest setup, and serves as a platform to mount bottles either between your arms, above the arms or behind the elbows. The BTA (between the arms and/or behind the arms) mount is available in different stack heights, and different angles, to suit the aerodynamically most optimal bottle position for every rider.
To determine the optimal width for you, measure the distance from internal edge to edge on your existing setup.
The curvature of the armrest is designed to follow the cross-section of the riders’ lower arm, thus avoiding exposed edges leading to an increase in drag.
When ordering, you need to specify the mounting pattern, i.e. distance between two vertical and horizontal mounting points. (See diagram on how to measure hole distance. The armcup is then specifically manufactured to fit those measurements. It is not possible to subsequently drill additional holes.
A standard, offset BTA mount 70 mm high either flat or with a 15 degree angle can be selected here.
The armrests are delivered with foam pads cut to size, and M5 bolts are included with the BTA mount.
More customisations are possible - get in touch for a quote.

The pads are mounted using four bolts, like your existing pads (which are typically mounted with two bolts in the left pad and two bolts in the right pad). Measure the horizontal distance between the left and right mounting holes, and the vertical distance between the two bolts on each side, and input in the form above when ordering.